Free PCB Sunday: Pick your PCB

BP-600x373

We go through a lot of prototype PCBs, and end up with lots of extras that we’ll never use. Every Sunday we give away a few PCBs from one of our past or future projects, or a related prototype. Our PCBs are made through Seeed Studio’s Fusion board service. This week two random commenters will get a coupon code for the free PCB drawer tomorrow morning. Pick your own PCB. You get unlimited free PCBs now – finish one and we’ll send you another! Don’t forget there’s free PCBs three times every week:

Some stuff:

  • Yes, we’ll mail it anywhere in the world!
  • Be sure to use a real e-mail in the address field so we can contact you with the coupon.
  • Limit one PCB per address per month please.
  • Like everything else on this site, PCBs are offered without warranty.
  • PCBs are scrap and have no value, due to limited supply it is not possible to replace a board lost in the post

Be the first to comment, subscribe to the RSS feed.

from Dangerous Prototypes https://ift.tt/2CbzZdt

App note: DC/DC converter testing with fast load transient

an_richtek_an038

Another app note from Richtek, this time about transient load testing on power converters and how you can make a simple and low cost fast transient tool. Link here (PDF)

Load transient testing is a quick way to check power converter behavior on several aspects: It will show the converter regulation speed and can highlight loop stability problems. Other power converter aspects like input voltage stability, slope compensation issues and layout problems can be quickly spotted as well. This application note will explain the practical use of load transient testing to diagnose DC/DC power converter problems.

from Dangerous Prototypes https://ift.tt/2oz4Ff6

App note: RT2875 3A automotive buck converter

an_richtek_an047

An application note from Richtek on buck converter used in automotive application. Link here (PDF)

Automotive environment can be quite harsh and designing electronics that need to work reliable in this environment takes special care, and often requires automotive qualified parts.

When designing voltage regulators that need to step down an intermediate voltage from the car battery supply, the car battery voltage fluctuation needs to be taken into regard.

The full operating temperature range needs to be considered for all aspects of the design, and all component parameters have to be checked over temperature.

The car radio receiver is nearby, which means that any switch-mode converter radiated emission needs to be minimized to avoid switch noise being coupled into the car radio receiver.

from Dangerous Prototypes https://ift.tt/2MK05cr