Kerry Wong did a teardown of a battery adapter for the Sony A6000 mirrorless digital camera and measured the poweroff current draw of the the camera:
With the battery adapter on hand, I decided to take a look at what’s inside and then use the adapter to measure the power-off/stand-by current of the Sony A6000.
I was not expecting to see much inside this battery adapter. After all, all it needs is the connection between the battery terminals and the input power jack and a resistor between the center pin and the ground in place of the thermistor that is used to sense the temperature of the battery pack. At the most, it might also include a reverse polarity protection diode.
But a quick measurement suggested that there must be some active components inside as the adapter itself draws around 17 µA current when connected to the power source. So clearly, there is some active circuitry inside.
Upon opening up the battery adapter, I was surprised to see the circuit board inside.
More details on Kerry D. Wong’s blog.
Check out the video after the break.
from Dangerous Prototypes http://ift.tt/2trRhy2