BUS PIRATE: USB Micro B connector test

header

USB Micro B is the connector of the moment, but we haven’t had a very good time working with it. The bog-standard Chinese generic Micro B connectors on Bus Pirate v5 and Bus Pirate NG1 break constantly. We tested a Micro B connector with through-hole support tabs on the latest Bus Pirate PCBs. It turned out really well.

Standard Chinese USB Micro B connector

china-standard

A ton of mom and pop factories around Shenzhen churn these out by the bucket load. It seems like a great part: ubiquitous and cheap, doesn’t require a special board slot, versions with extended leads and centering pegs are easier to hand solder. Unfortunately, every connector soldered by every member of our team has eventually decided to exit the PCB.

This connector is optimized for paste stencil and reflow soldering. Most support should come from two solder pads under the connector that are impossible to reach with a soldering iron. Maybe it could be done with hot air, or the QFN “solder from the bottom of the board through a via” hack.

Connectors with supporting through-hole tabs

usb-old-new

The generic Chinese connector (left) has six solder pads holding it to the PCB. Four can’t be reached with a soldering iron – the two under the front, and the two recessed pads at the back near the pins.

A Molex 47589-001 (right) with through-hole support tabs went into the next revision of the Bus Pirate boards. The tabs aren’t long enough to go completely through a 1.6mm PCB, but they can still be soldered in place from the top of the board. It’s much more expensive – essentially free vs $0.50 each – but we’re optimizing for hand assembly, not production.

usb-connector

Now we’re living the dream. The four tabs are really secure, and we don’t have to treat the prototype like glass. The next step is to find the most widely available Chinese equivalent.

 

 

 

from Dangerous Prototypes https://ift.tt/2OSNNvf

Related Post

Deja un comentario

Tu dirección de correo electrónico no será publicada. Los campos obligatorios están marcados con *