Guitar Amp builder notes — AF power amplifier dummy load

DSC_2129-1 (1)Vasily Ivanenko has written an article detailing his AF dummy load project:

I’ll describe a simple 8, or 4 Ω dummy load to test your home brew guitar power amplifiers.
Low cost 16 Ω / 25W wire wound, aluminum shell, chassis mount resistors seem abundant.  I got mine on eBay.  Wire wound resistors vary in quality, design and tolerance. Some even exhibit low inductance by winding with an Ayrton-Perry bifilar technique.  Resistor tolerances range from 10% down to ± 0.5 % + 0.05 Ω.  Typical manufacturer power ratings are done at 25C, however, these devices are meant to sit on a heat sink when used and that’s why the aluminum housing contains 2 relatively large mounting holes.

Project info on QRF HomeBuilder blog.

from Dangerous Prototypes