Recently I started work on a new board. This one will be a front door entry system, so I decided to go with something that could read my NFC implant but also had a numeric keypad for the kids (and anyone else) to use. Not everyone wants to be chipped. Crazy, isn’t it? I’ll write more up on the board when it gets closer to completion, but for this post I’m going to concentrate on a small PCB antenna that’s intended for use with a tiny implanted tag. I’ve successfully used a wirewound inductor before, but I decided it was time to try a PCB trace antenna. This is the most common way to make an NFC reader, but nobody seems to have tried to tune one for an implant – probably because it means it will be worse at reading larger tags. Anyway, this is about creating a small PCB antenna and more importantly tuning it so that it read well.
Check out the video after the break.
More details on 0xFRED blog.
from Dangerous Prototypes http://bit.ly/2SWXbU1