Small motor controller with integrated position sensor

pdouble_board-600

Ben Katz writes:

A while ago I added the hall effect encoder IC I’ve been using directly to the motor controller PCB.  The controller sits directly on the back of the motor (with a magnet added to the motor shaft), and the phase wires solder straight in.  I also have a pair of board-mounted XT30 connectors on the DC bus for easy daisy-chaining.  Otherwise, the board is basically identical to the previous version of this controller.  I’ve now built over a dozen of these, and have had no problems.

See the full post on BuildIts in Progress blog.

from Dangerous Prototypes http://ift.tt/2FcS2jy

Related Post

Deja un comentario

Tu dirección de correo electrónico no será publicada. Los campos obligatorios están marcados con *