Teardown of an Extech 380460 milliohm meter

Extech380460

Kerry Wong did a teardown of an Extech 380460  miliohm meter:

This is a highly specialized instrument, all it does is measuring low ohm range resistance (from 200mΩ to 2000Ω in five ranges) and nothing else. The meter came with a rugged case which is handy for field use, although its portability is hampered by the requirement of a wall outlet.
Since this meter is designed for low resistance measurement, it came with a set of 4 wire Kelvin clips. The stock leads are not my favorite though, as the design uses rubber rings to hold the two clip pieces together. One issue of this (instead of proper spring tensioned clips) is that the tension is quite weak and it is difficult to make secure contact with small dimension leads. Also, the rubber ring is likely to lose tension and fail over repeated use.

See the full post on his blog.

Check out the video after the break.

from Dangerous Prototypes http://ift.tt/2AiY3Wn

Related Post

Deja un comentario

Tu dirección de correo electrónico no será publicada. Los campos obligatorios están marcados con *