UCload: revisited


Sjaak has posted an update on his uC controlled dummy load project we covered previously:

I finally found some time to check out the UCload project. A couple of weeks ago I quickly soldered the PCB and wrote a quick’n’dirty firmware for it. The basic functionality was working, but it wouldn’t do good for the shiny display.
Today I locked myself in my mancave and shut myself off from the world. Turned the light down, pulled loud music from the speakers and started coding like hell!! Not exactly but I found some time to write some more decent firmware for this load. In a previous revision of the PCB I forget the pull up resistors and swapped the SDA and SCL signals. I corrected that and made some small other changes (still ****ed up the silkscreen) in revision 2. The hardware is quite OK and rock solid (prolly more due to the robust FET then my analogue skills :)). However I managed to use a 1n4148 diode to measure the temperature. Connect it to the heat sink and if that one gets to hot turn on a fan. It accuracy is terrible but capable of detecting over temperature 🙂

More details at smdprutser.nl project page.

from Dangerous Prototypes http://ift.tt/1pZP2LS

Related Post

Deja un comentario

Tu dirección de correo electrónico no será publicada. Los campos obligatorios están marcados con *