Weather station project


Alvaro Prieto has been working on a wireless weather station project:

After playing around with the breakout boards, I decided it was time to integrate it all in a single board. I named it Chaac.
This is where I ran into issues with MBED. Making the board support package (BSP) for a custom board was not trivial. Another issue was that I couldn’t get the low-power modes working quite right. At the same time, I decided to ditch GPS, since the weather station is unlikely to move without my knowledge . With the new requirements, I ended up switching to an STM32L432KC based board.

See the full post on his blog.

from Dangerous Prototypes